Acroprint ATR120 Manuel d'utilisateur télécharger pdf (Page 26)

- 22 -

16. Connecting External Signal Devices

The connections for an external signal device (bells, horns, buzzers, chimes, etc) are made via a 2-wire

Green terminal block on the back of the clock above the power jack. Connections are made by pressing

the orange wire release tabs below each wire hole, fully inserting the wire and releasing the clip. Gently

pull on the wires to make sure they are firmly secured in the terminal block.

A relay is required in order to use a bell or horn. Please call Acroprint or your Dealer to order the relay (PN

01-0230-000).

When a signal is activated by the clock the internal contacts of the relay close and complete the circuit.

These internal contacts are "dry" and supply no voltage. Voltage applied to these contacts must not

exceed 30 volts. The relay then activates the 120v external signal device such as:

65-0103-000 "Grille Horn"

65-0104-000 "4-1/4" Bell"

65-0105-000 "8" Bell"

For more information about connecting an external signal device using a relay go to:

http://www.acroprint.com/resources/user-manuals

Locate “ATR120/ATR120r Time Clock” in the list of products, and click on the product name to reveal a list

of all available support documents, including “Connecting an External Signal Device.”

17. Specifications

Power Supply

Input: 100v / 240v, 50/60 Hz, 0.6A

Output: 13vDC, 1000mA

Dimensions

Approx: 9 x 8 x 5 (H x W x D)

(230 x 205 x 128 mm)

Weight 3.35 Lbs (1.524 Kgs)

Usage Environment

32º - 104º F (0 – 40º C)

10 - 60% Relative Humidity

Time Card Size 86 x 185 x 0.35 mm ( W x L x Thk )

Circuit Board Battery CR2032 3v Lithium Coin Cell

Ribbon Cartridge Red

Black

1 2 ... 21 22 23 24 25 26 27 28 29 30

Pas de commentaire

Acroprint ATR120 Manuel d'utilisateur Page 26